360  10.06.2018

- Saving of the Feed-Settings is changed to limit the number of write cycles.
- The positions of X and Z is now saved for every mode until power down of the unit. Now the ELS shows positions for every mode, so you can easily switch from mode to mode without the need of reentering the desired positions.


359 12.02.2018
- The P0 key now sets the current position in ZP or XP when pressed if ZP or XP=0.
  So instead of setting XP or ZP to zero, if it is already zero you can update ZP or XP with the current position. This is handy when you want the current position be an endpoint for the next operation.
- For taper and radii the els now keeps a clearance in Z of at least 0.2mm.


358 Beta 11.01.2017
- First english software version
- Language can be selected in the settings menu


357 Beta 01.01.2018
- New mode UNDERCUT. This mode creates a thread undercut according to DIN EN 76-1
  The depth in X is all you need to enter, the lenth in Z is calculated by the control.
  It cuts a 30 taper, followed by a short straight way and ends in a defined radius
  ATTENTION: Only use 55 or 35 cutters, as others will cause a collision

